Net-optics 10 GigaBit In-Line Regeneration Taps Instrukcja Użytkownika Pobierz pdf (Strona 12)

10 GigaBit In-Line Regeneration Tap

Connecting to Monitoring Devices

Using Standard SC Fiber Cables

If you did not purchase a Net Optics Custom Monitoring Cable, you can easily

modify a standard ber cable by splitting apart the connector on one side of the

cable (see Figure 6).

Warning: Uncovered connectors can emit dangerous laser light. Do not operate

devices with uncovered connectors.

To connect a standard monitoring cable:

1. Prepare a standard SC cable by removing ber strands from the connector clip

so you have a cable similar to Figure 6.

2. Connect the double connector side of the cable to a Regeneration Tap Moni-

toring Port.

3. Connect one single end of the cable into the Rx connector of the monitoring

device’s NIC port to monitor the link.

4. Connect the other single end of the cable into a second Rx connector of the

monitoring device’s NIC to monitor the link.

5. Close the open Tx connectors on the monitoring devices’ NICs with a suitable

cover to prevent injury from laser light.

6. Repeat steps 1-5 for each monitoring device you wish to connect

to the Regeneration Tap.

Figure 6: Splitting a Standard SC Cable

To Monitor NIC Rx

To Monitor Port

Split Connector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Net-optics 10 GigaBit In-Line Regeneration Taps Instrukcja Użytkownika Strona 12