Net-optics iTap 10 GigaBit Port Aggregator Instrukcja Użytkownika Pobierz pdf (Strona 58)

iTap 10 GigaBit Port Aggregator

54

Command Sub-Command Syntax Description

Set

(continued)

Username set username

<username>

Where <username> is the

authorized user's name,

32 characters or less

Password set password

<password>

Where <password> is the

authorized user's password,

32 characters or less

Mgtport set mgtport

<parameter>

Where <parameter> is

1 = Managment Port on

2 = Management Port off

(other values not applicable)

Enable Port set enable port

<port ID>

<parameter>

Where <port ID> is 1 or 2

and <parameter> is

1 = Monitor Port Laser Enabled

2 = Monitor Port Laser Disabled

(other values not applicable)

Mode Port set mode port

<port ID>

<parameter>

Where <port ID> is 1 or 2

and <parameter> is

1 = Tap mode

2 = Aggregation mode

(other values not applicable)

Note 1: Both Monitor Ports

must always be set to the

same mode or the device

behavior will be undened.

Note 2: When changing from

Tap to Aggregation mode,

you must change port 2

before you change port 1.

CRCregen Port set crcregen port

<port ID>

<parameter>

Where <port ID> is 1, or 2

and <parameter> is

1 = CRC regeneration on

2 = CRC regeneration off

(other values not applicable)

Note: CRC regeneration is

helpful to make sliced and

timestamped packets valid

Stamp Port set stamp port

<port ID>

<parameter>

Where <port ID> is A or B

and <parameter> is

1 = Timestamping on

2 = Timestamping off

(other values not applicable)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Komentarze do niniejszej Instrukcji

Brak uwag