Net-optics xStream 40 Instrukcja Użytkownika Strona 1

XF-40 AggregationXF-40-DIR FilteringXF-40-LB Load Balancing Quick Install Guide

10Step 2 (cont.)Connect DC Power For DC powered models, you must supply your own power cables and one Phillips screwdriver. DC power cables must have

11 ReturnGround-48VDCChassisGroundReturnGround-48VDC

12Step 3Log into the xStream 40The xStream 40 is shipped with a default Management port IP address. If you prepare your network to accept the default

13 ManagementConsoleComputer with terminal emulation softwareDB9 to RJ45 console cable

14Step 4Congure the xStream 40 IPTo assign a new IP address using the CLI:1. After the command prompt, type in the following command to set the new

15Step 5Check the xStream 40 Installation After you have connected the xStream 40 device, verify that it is functioning correctly by checking the lin

16 www.netoptics.comIf you have questions while your product is under warranty or you are enrolled in a

2 PLEASE READ THESE LEGAL NOTICES CAREFULLY.By using Net Optics xStream 40 software, you agree to the terms and conditions of usage set forth by Net O

3ContentsxStream 40 Package Content 4xStream 40 Appliance Overview 5Connect AC Power 8Connect DC Power 10Log into the xStream 40 12Congure the

4xStream 40 Content This guide provides the initial steps to set up and congure the xStream 40 Appliance. The xStream 40 Appliance package has been d

5xStream 40 Appliance Overview48 -10G Network/Monitor Ports Activity LEDLink LEDConsole PortManagement Port4 - 40G Network/Monitor Ports ManagementCon

6Step 1Rack Mount xStream 40The xStream 40 device is designed to mount in a 19-inch rack, occupying 1U of height. Do the following to install the xStr

7

8Step 2Connect AC PowerCaution: Always connect the earth electrical grounds rst, and keep the earth grounds connected whenever you are working on the

9EarthGroundRedundant Power