Net Optics Smart Filtering Appliance Instrukcja Użytkownika Strona 27
- Strona / 57
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
23
*** Condential - DO NOT Distribute ***
Director
Connect Director With In-line Network Links
To connect Director to the network using an in-line installation, be sure that at least one of your DNMs is an in-line
model. Tap port-pairs for each link are located side by side, with three links across the top row and three links across
the bottom row. This is true for both Fiber and 10/100/1000 DNMs.
www.netoptics.com
™
Director
1
2
B
A
1
6
2
7
3
8
5
10
4
9
A B
In-Line
10/100/1000
10
100
1000
LINK
ACT
Link # 7 8 9
Link # 10 11 12
Port # n2.1 .2 .3 .4 .5 . 6
Port # n2.7 .8 .9 .10 .11 .12
In-Line
GigaBit
1 2 3 4 5 6 7 8 9 10 11 12
A B A B A B
Port numbers in purple
In-line link numbers in green
Port # n1.1 .2 .3 .4 .5 . 6
Link # 1 2 3
Port # n1.7 .8 .9 .10 .11 .12
Link # 4 5 6
Port and link numbering for in-line DNM modelsFigure 20:
To connect an in-line network link:
Plug the appropriate cable into an odd-numbered Network port (Port Nm.o).1.
Plug the other end of the cable into the source switch or router. The Link LED for the port illuminates after a short 2.
delay to indicate that a link has been established.
Plug another cable into the connector immediately to the right of Port Nm.o. It will be numbered 1 higher, or Port 3.
Nm.(o+1).
Plug the other end of the cable into the destination switch or router. The Link LED for the port illuminates after a 4.
short delay to indicate that a link has been established. If present, trafc passes between the source and destination
switches or routers. If the trafc bandwidth is greater than about 300 Mbps, the two Link LEDs blink.
Repeat for all desired in-line network connections.
- User Guide 1
- Contents 3
- Chapter 1 5
- Introduction 5
- Key Features 6
- About this Guide 7
- Director Architecture 8
- USB port 9
- Director Management 9
- Typical Application 10
- Director 12
- Monitoring tools 12
- Director Front Panel 13
- Director Rear Panel 14
- Chapter 2 15
- Installing Director 15
- Plan the Installation 16
- Slot 1 Slot 2 17
- Connect Power to Director 18
- CLI sign-on bannerFigure 11: 19
- Shell login promptFigure 12: 19
- Shell login Figure 13: 19
- Log into the CLI 20
- CLI Interface 21
- Port numbers in purple 26
- A B A B A B 27
- Check the Installation 28
- Chapter 3 29
- Monitor Port 2Network Port 1 30
- Monitor Port 1Network Port 3 30
- Monitor Port 9 31
- Monitor Port 10 31
- Network Port 10 31
- Network Port 11 31
- Create Filters 32
- Create Complex Filters 33
- View lters 34
- Understand lter interactions 37
- Address Filter 39
- 2 n1.1 m.1 39
- Chapter 4 43
- Appendix A 44
- Director Specications 44
- Specications, DNM 45
- Environmental 45
- Certications 45
- Available Models 45
- Appendix B 46
- Command Line Interface 46
- Filter parameters 52
- Appendix C 53
- Protocol Numbers 53
Glowshift Diesel Set- 60 PSI Boost, Pyrometer EGT, Transmiss Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Zubehör fürs Wasser Glowshift Diesel Set- 60 PSI Boost, Pyrometer EGT, Transmiss.
Wir stellen 1 PDF-Handbücher Glowshift Diesel Set- 60 PSI Boost, Pyrometer EGT, Transmiss zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentarze do niniejszej Instrukcji